Heated Grips Hot Grips Brand - 1" bars - 2 lengths - Made in USA

Heated Grips Hot Grips Brand - 1" bars - 2 lengths - Made in USA
    Close Heated Grips Hot Grips Brand - 1" bars - 2 lengths - Made in USA

    Product Description

    Hot Grips only available in certain sizes until sold out.

    Hot Grips are widely known as the best heated grips available. The difference between this US made brand and all others (china made) is in the consistent quality, even heat output throughout the entire grip length and all round. No Hotspots. Another big difference is heat output where is matters ... Your Hands. US made Hot Grips brand heated grips have less heat-loss through the handlebars and more heat output to the outside. Hot Grips are guaranteed never to burn out and are available in different lengths for different bikes.

    US Made HotGrips are available with open or closed ends or optional Chrome End-caps.
    The standard kit consists of a left and right side heated grip, one hi/lo/off switch, one resistor and installation instructions. A handlebar mounted switch housing is available.

    We are now offering a genuine Warm & Safe Heat-Troller or Symtec electronic controller upgrade, at a strongly reduced bundle price, with every set of Hot Grips. If you choose the upgrade then the package consists of both grips, one controller of your choice and all necessary instructions. If you are not wiring into a switch controlled accessory lead, on your vehicle, use a relay to make sure the heated grips are turned off when you turn your ignition off. Click here for a relay wiring diagram

    Hot Grips Mfg. recommends using a heat resistant 2 component adhesive.
    Powerpoxy, which we have recommended and sold for many years, is no longer available. At this time, we do not have a replacement product on the shelf but you can find high temperature (250 °F or higher) in most local stores like AutoZone, Napa, Wal-Mart etc.

    Measure the length of your original grips and choose between open or closed ends (or chrome caps).
    4 3/4" (4.75) is standard length on most bikes.
    If your grips are slightly longer, go with 5.25.

    • Will fit all 1" bars
    • Complete with 3- position switch (high and low) and all wiring.
    • Consumption only 7 watts (0.58 amps) on low and 16 watts (1.33 amps) on high, per grip
    • Original Hot Grips - MADE in USA
    • Heat-Troller Upgrade available with purchase of  one set of grips
    • Guaranteed not to burn out.
    • Did we mention US made ??  (it has to mean something these days)

    Average Customer Review: Not yet rated
    Write an online review and share your thoughts with others.

    There are no reviews

    Categories