Canyon Dancer Peg Harness Kit

Canyon Dancer Peg Harness Kit
    Close Canyon Dancer Peg Harness Kit

    Product Description

    Canyon Dancer Peg Harness Kit with direct and remote mounting brackets.

    The Peg Harness provides the ultimate in transport security when combined with the Bar Harness. It essentially takes the weight of the bike out of the equation, leaving the Bar Harness to just keep the bike upright. No need to compress the forks. No need to tie the back of the bike down. No need for a wheel chock although a chock helps keeping your bike straight up when loading lone.
    The Peg Harness pulls the weight of the bike down by the foot pegs or floor board brackets which keeps the front wheel straight by virtue of the steering geometry. A combined downward pull of only about 100 pounds is all that is necessary to secure the heaviest bike. That is is less weight on the pegs than when standing on them. If you have plenty of floor-to-peg clearance, you can use the Direct Anchor Peg Harness configuration which requires 8 inches of clearance.

    Can I just use the Peg Harness by itself ?

    The stress on the truck bed when you make a turn is redirected from being equal on both sides, to almost all on one side. Using a Bar Harness on the front keeps the bike vertical and serves to equal out the pull on the truck bed.

    Can I still close my tailgate with the remote anchors in place?

    Yes.  If your bike will fit, your tailgate will close. The remote anchor/ratchet assembly lies flat against the rear of the bed.

    Installation Instructions:

    Click here to download a PDF file of the full installation instructions.

    Tie down is simple once the Bed Bolts are in place and here is how it's done. Please refer to the above photo.

    • Download the complete installation instructions for the Peg Harness.
    • Screw the roller/yoke assemblies into the two Bed Bolts by hand and adjust them so the rollers are crosswise to the bed. They don't need to be tight. Screw them down by hand until they stop, then back them off slightly.
    • Position the bike with the foot pegs directly over the roller/yoke assemblies and allow the bike to rest on it's side stand while you install the Bar Harness to steady the bike.
    • Slip the loops in the webbing over the foot pegs and feed the webbing down and through the yoke/rollers and toward the rear of the hauler./li>
    • Feed the webbing through the two ratchets at the rear of the hauler and slip the ratchet anchor pins into the two 5/16 inch holes drilled in the rear of the bed. Be sure to make at least two wraps of the webbing around the ratchet barrel.
    • Tighten the straps by ratcheting them down evenly until there is approximately 100 pounds of combined downforce on the foot pegs.
    • AAdjust the Bar Harness so the straps don't flap in the wind and you are ready to go.
    • To release the bike, release the Peg Harness ratchets first, leaving the Bar Harness to steady the bike./li>
    • Standing over the seat, or to the left of the bike, lower the side stand and release the right side of the Bar Harness. Then release the left side and allow the bike to rest on the side stand.

    Average Customer Review: Not yet rated
    Write an online review and share your thoughts with others.

    There are no reviews