Dual Heat-Troller - Dash Mounted with universal coax connectors for heated gear
Control 2 separate garments with one controller permanently mounted on your motorcycle. This dual controller provides the cleanest setup to run heated gear. When installed right, all you see are the 2 control knobs with LED's and the 2 female coax connectors ready to plug in your heated gear.
Heat-Trollers are true pulse-width modulating controllers, famous for
their high quality and reliability.
This is not an old-fashioned
rheostat. Heat-Trollers cycle current on and off in seconds, depending
on the setting you choose. They do not heat up and actually reduce
amperage draw, on your electrical system, when turned down.
- 'Dual' means you can control your heated gear with 2
separated heat zones. For instance, you can control your gloves separate
from the jacket or a heated jacket and heated seat. Basically any 2 heated garments but NOT heated garments
for 2 different people. Beside from probably drawing too much,
controlling the temperature on an other person's heated garment, without
that person being able to reach the control, is not a good idea.
-
'Coax' means it is set up to work with the round coax plug standard
found in pretty much all brands of heated clothing. Yes, you can use
this controller with your heated gear, any brand heated gear, as long as
it uses a coax connector. (most brands do)
SAE, the flat 2 prong plug found on some battery chargers and older heated gear, is an other widely used connector. We have an adapter available to use this Coax controller with SAE gear.
Comes with battery harness with covered fuse holder.
Use this
controller with heated liner, pants and gloves, with coax connector, up
to a maximum draw of 15 amps.
