Heat-Troller Dash Mounted for Heated Grips.
This universal single zone pulse-width modulating controller can be used with any brand or model* heated motorcycle, ATV or snow mobile grips.
The control knob and LED are mounted on circuit board at the end of a 5ft extension so you can install it anywhere on your bike while keeping the actual controller safely hidden.
Dash Mounted means you have to drill a small hole in a panel of your choice.
Basically anywhere within safe reach while riding.
The open circuit board is obviously not waterproof. When installed in a dry panel space, the rubber ring below the control knob is sufficient to keep all moisture out.
If there is risk for moisture to come in, simply pack the circuit board with dielectric grease.
Hooking up heated grips is simple.
2 wires for ground and positive and 2 wires to the heated grips which are usually wired in parallel. (check with grip manufacturers manual when in doubt)
Warm & Safe Heat-Trollers are a great alternative for the many unreliable
Chinese made controllers usually supplied with heated grips.
Dimensions (inch / mm): 1.5 x 2.25 x .85 or 38 mm x 57 mm x 21.5 mm
* any brand heated grips without built-in controllers or thermistors.
